M4 INTERIOR DOOR TRIM

Made from Dry Carbon!

Our parts are hand-made made using the highest quality of carbon fiber so you can rest assured you are receiving a product that's worth your hard-earned money.

Dry carbon fiber is made by coating each specific weave with an appropriate amount of epoxy while it's being made before it has set or cured. This optimizes its strength and limits the amount of unnecessary epoxy in the structure. This is how it significantly cuts down on weight.

Advantages of Dry Carbon

Stronger – the autoclave process eliminates air bubbles and other impurities, strengthening it significantly.

Lighter – pre-preg fiber weighs up to 70% less.

Quality - Hand-made perfected carbon leaving you a high-gloss finish with no impurities.

INSTALLATION:

Make sure to do the install in a warm area to optimize the 3M adhesive. If you aren't in a warmer climate, simply use any sort of heating device (hairdryer, heat gun, etc.) and heated up 3M before application.

*Doesn't need to be hot, just warm.*

• Clean the surface and make sure no dust particles/contaminants are on the surface.
• Allow the surface to dry and make sure there is no moisture left.
• Lineup product and do a test fit before removing 3M.
• Once fitment is confirmed, remove the 3M, carefully lineup the product, and press on.
• Apply firm even pressure along the surface for 2-3 minutes.
• We recommend taping painter's tape across and letting the product sit overnight for the best results. It's completely fine if you don't have time but just make sure the product has properly adhered and you're good to go!